NEW! POWERVOICE-X serie now with digital power amp technology:
The POWERVOICE automatic mixing amplifiers from Phoenix Professional Audio have been redesigned and improved especially in their electronics: A new digital power amplifier (Class D) has been installed in the devices - the state of the art technology. The fans in all new amplifier models are temperature controlled and, in contrast to the fans of the previous versions, are very quiet. The new series is also very energy efficient.
The mixer amplifier is equipped with 8 inputs and 3 audio outputs, audio DSP1 system, MIC.-LINE selector, automatic NOISE-GATE system and MP3 player (USB / SD) with BT receiver (for direct connection with Bluetooth-enabled devices).
All 8 inputs can be switched between MIC and LINE sensitivity by means of DIP selector switches. Each of the 8 inputs has switchable phantom power and an HPF filter (100Hz). All 8 universal inputs are equipped with an analog automatic NOISE-GATE system.
NEW! In the POWERVOICE-X series, a 2-level mains filter is installed to prevent external interference (such as bells ringing).
Energy saving: In full operation, the automatic mixing amplifier has an efficiency of over 90% and thus is particularly energy efficient.
The devices are suitable as table version as well as for 19" installation (3U).
To increase power, the digital power amplifiers of the WM-DT series and the digital DIGIVOICE DSP beam steering line arrays are available.
- NEW: With digital power amp (Class D)
- NEW: USB / SD MP3 player now with BT receiver
- 8 inputs on XLR (MIC.-LINE by DIP selector switch)
- LINE input (LINE-7 IN) on RCA
- 8 x input-GAIN control
- 8 x input LF / HF EQ
- MASTER SECTION LF / HF EQ
15 Band Input Parametric EQ with 5 parametric filters
- PEAKING EQ
- 2 x PRESETS
- Feedback limiter "Phase shifter" or "adaptability-automatic"
- Digital NOISE-GATE and LIMITER (software)
- REMOTE interface for wired remote control, manual switching between presets
- 2 100V / LS lines outputs (1 adjustable zones)
- PRE-MASTER output before PEQ and MASTER (balanced to XLR)
- MIX OUT output before PEQ and MASTER (balanced to 3-pin jack
- POST-MASTER DSP output (balanced to XLR)
- PRE-MASTER input (balanced to 3-pin jack)
- INFO OUT PRESET 2 (two relays with 2 NO contacts) for e.g. Connection of additional LS line with PRESET 2
- Output RECORD for recording devices
- Phantom power 24VDC
- USB interface
- System Software
-5 to + 40C
1 x 600 watts sine wave
Analog / digital gain
For all MIC-LINE analog inputs on the back and one MAIN VOLUME Digital in the device configurator
19" mounting angle (L / R)
8 x MIC.-LINE (with selector switch DIP)
Audio input line
Unbalanced. LINE IN to RCA (input 9) or LINE-IN jack, (0.1V-1.5V)
MIX OUT, POST MASTER, PRE MASTER, REC OUT.
Automatic NOISE GATE
Analog automatic NOISE-GATE system
The amplifier is suitable both as table version and for 19" mounting (3U).
Configurable (device configurator in the range of 0.0 to 170 mtr. (499.92 ms)
Digital & analog volume controls
443 mm (W) x 135 mm (H) x 340 mm (T) Table housing, 19" mounting by additional mounting bracket
PROTECT, output level (-27dB to + 3dB), signal IN
LF / HF (+/- 12dB)
Equalization Parametric EQ
20-20kHz / -20 + 12dB / 0.05-3db (oct)
Equalization Parametric EQ @ input
15 Band Input Parametric EQ with 5 parametric filters: 1.Peak 2. LoSh6 3. LoSh12 4. HiSh6 5. HiSh12
Exit 1/2 (ZONE 1/2)
Automatic feedback suppressor in the range 20 Hz to 20 kHz or digital frequency shifter (Freq. Shift 1.7 Hz, 2 Hz, 3 Hz.)
40 Hz to 22,000 Hz @ -3dB
HPF filter (100Hz)
+ 6dB / -40dB (SLOW-NORMAL-FAST)
3 U (U)
SLOW / NORMAL / FAST: yes
Noise Gate [LEVEL / ATTACK / RELAY]
-90dB / -3dB (300us-5000US) (1 ms 3000ms)
Digital power amp (Class D); MP3 player (USB / SD) with BT receiver
600 watts sinus
In the device configurator
PEQ filter (output)
PEAKING EQ, LoSH6, LoSH12, HiSH6, HiSH12
24 VDC, switchable to each input
230 VAC - 50/60 Hz
Preset-1, Preset-2 with plain text
On-delay, current limit (short circuit), over-temperature protection, inductive load, limiter
Signal to Noise Ratio
Can be set in the device configurator @ NOISE GATE / ON
Sound adjuster inputs and sum
LOW (LF) 100 Hz, HIGH (HF) 10 kHz, (+/- 12 dB)
Speaker outputs, floating
100 V - 70 V - 50 V - 8 and 4 ohms, separate 100V output "SPK-ZONE-LEVEL" with 6-step control 0V to 100V, load is max. Power of the amplifier
Temperature (AMP) monitoring
System shutdown at 92 degrees
Better than 0.1%